My GPU’s fans spin either at 100% or stand still. they rarely ever dip below 1000rpm, and if so, only shortly (see images below). This worries me, and I am 99% sure I’ll refund that card, but before buying a new one, I want to make sure the fault is not with my system. This is my first AMD GPU and I am pretty green in Linux.
So far I tried adjusting the GPU’s fan curve, with fan-control and CoreCtrl but it didn’t change the erratic fan behavior.
I checked my BIOS for 0rpm mode, but couldn’t find anything. It also only let’s me configure CPU and sys fan curves.
Is there anything I can try before sending the card back to fix these issues or -best case- verify the card is actually causing the issue? I’d hate to get a replacement and face the same issues again.
specs
Linux Mint GPU: acer AMD RX7600XT CPU: AMD Ryzen 5800x RAM: 16GB DDR4 @3600mHz; G.Skill Tridentz Neo MoBo: MSI B550Pro-A
images
Temperature and fan curves over the span of 20min; green curve is fan rpm, yellow curve is GPU junction temp, blue curve is GPU edge temp
Update I REMed it and will get the same.card again, but from a different, more widely adopted vendor. I don’t want to spent another week troubleshooting an issue I may not have the skill to fix.
Thank you all for your input :)
Have you tried using LACT? https://github.com/ilya-zlobintsev/LACT
I have been annoyed for years but this is what saved my sanity when it comes to configuring GPUs on linux.
Also what specific model of card made by which company are you using? Fan curve config is something handled by each third party company differently.
I took a bit of a trustfall and bought an acer rx7600xt. Plan to get the same chip, but from a different, more reputable vendor next.
But I didn’t try Lact, thanks. I’ll give it a shot.
It probably is in mints repositories but you will figure it out… But yeah that card shouldnt have any issues to stay cool in idle without much fan spin. Its normal for the fans to spin up pretty hard when gaming but if its during idle too then thats odd. You should add GPU usage to your psensor chart and add a screenshot of that.