• dmtalon@infosec.pub
    link
    fedilink
    English
    arrow-up
    1
    ·
    5 hours ago

    Mine went up with the house in 2009 and are not Smart. I bought a “smart” device to smrtin up my garage doors, where the instructions said to just connect where the inside button does and it’s internal relay to trigger the door

    Unfortunately my doors were kinda smart. The button in my garage has a motion sensor on the wall switch that triggers the overhead light, but it still uses just two wires to connect to the controller. They are still simple contact switches to open/close, but they carry some voltage/data across the line and that was preventing the smart controller relay from being able to close the circuit.

    I ended up making a standard 12vdc car relay dongle to overcome this voltage on the line.

    Now, home assistant triggers the smart device, which triggers my little relay to make the connection and boom, bobs your uncle.

    • Bell@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      3 hours ago

      One of my doors had this “not a dry contact” problem. I opened up the wall switch for it and soldered wires onto that internal switch, then ran those to my controller.

      • dmtalon@infosec.pub
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 hour ago

        That was my first attempt, and actually how the connection remains but that voltage on the line was preventing the micro/solid state relay from operating

        I am using “GoControl/Linear GD00Z-4 Z-Wave” device.