You probably have a higher attack surface from the gremlins in your walls. OTOH, Amazon knowing that you use Mullvad is a tangible downside, as they will probably use that to stick you in a marketing group or something. Monero is still an easy solution with the ~same cost if you’re concerned about that.

How would Amazon track a voucher? It’s a physical scratch off code, sealed by Mullvad before they send it over to Amazon. More importantly, if you think that was possible why would Mullvad be unaware of it and/or lie about it? Just go with the vouchers if you want untraceability. They’re also cheaper in USD than other methods IIRC, at $29/6 months and $57/12 months.

Vote with your wallet regards any sort of purchase. By giving money to someone you are giving them the most encouragement possible to continue doing what they’re doing. If you purchase something that you end up not liking, they will still receive your initial vote loud and clear. The gaming industry especially has shown us that companies will happily take both the money and the negative review and say ‘thank you’.

I feel piracy for demo purposes is fully justified if you buy it after you like it. People always say vote with your wallet but it’s more like gambling with your wallet if you don’t get to see and touch the product before you make the purchase. Giving proper demos should be more common with digital media.

Everyone fully missing the point here. This is the banner image for !linux@programming.dev (that’s not where we are right now for the record), and it has a normal JPEG size of 7.7MB. When it’s served as WebP it’s 3.8MB. OP is correct that this is very stupid and wasteful for a web content image. It’s a triple-monitor 1440p wallpaper that’s used verbatim, and it should instead be compressed down to be bandwidth-friendly. I was able to get it to 1.4MB at JPEG quality 80, and when swapping it out in dev tools and performing A/B testing I can’t tell the difference. This should be brought to the attention of a mod on that community so it can stop sucking people’s data for no reason.

JXL is the best image codec we have so far and it’s not even close. I did a breakdown on some of its benefits here. JXL can losslessly convert PNG, JPG, and GIF into itself, and can losslessly send them back the other way too. The main downside is that Google has been blocking its adoption by keeping support out of Chromium in favor of pushing AVIF, which started a chicken and egg problem of no one wanting to use it until everyone else started using it too. If you want to be an early adopter you can feel free to use JXL, but just know that 3rd party software support is still maturing.

Something you might find interesting is that the original JPEG is such a badass format that they’ve taken a lot of their findings from JXL and made a badass JPEG encoder with it named jpegli. Oddly, jpegli-based JPEGs are not yet able to be losslessly-compressed into JXL files, per this issue - hopefully that will be fixed at some point.

Yes it’s lossless. JPG->JXL lossless compression is generally 20% savings for free.

Semi-related, can these automations really be relied upon for quality, or is there a system to help find the best copy? When I’m downloading books I do it manually through Anna’s Archive and I always download as many unique versions of a book that I see, then open them all and compare their internals to see which one I keep. Often not many ebooks are suitable for using my own font and layouts with Koreader.

Arch should be fine for university stuff. The main problem with Arch is not Arch itself, but all the software it tracks being very fresh. You’ll be pulling updates as they come down the line, and that may result in temporary bugs or day-to-day workflow changes - caused by the software developers themselves. I don’t think an Arch system is unusually unstable or prone to breaking, but last year they did brick everyone’s GRUB loaders by pushing an update too early (post-mortem here). It’s up to you, but if you want to err on the side of system/software stability I would go for Mint/OpenSUSE Tumbleweed/Debian.

I don’t have any practical experience with EndeavourOS but TMK it’s just preconfigured Arch and it uses the default repos, so that sounds good to me. Vanilla Arch is not inherently better or worse, it’s just a more minimal starting point.

The readme links to this one. It will automatically update after manual installation.

Are NPCs silent when talking? If so you’ll need to install faudio into your Wine prefix with Winetricks. Running with Steam may help a little also but l don’t remember if Proton includes faudio by default.

As for the cart crashing that’s probably just Skyrim. The opening cutscene is notoriously buggy.

Yeah I wouldn’t bother. It intends for you to have a duplicate copy on every device, which is probably not what you want. Syncthing is really good for things like synchronizing notes, calendars, password databases, music, etc to your devices. Things that you want to access in both places, but that are usually disconnected from each other from time to time.

Remember that cheap subscriptions for digital media is the compromise we made. If they want to fuck around and find out then you should remind them that you can just as easily pay nothing for the same content.

Conduit is also licensed under Apache 2.0, so it could also be taken closed source at any point in time. The reason this wouldn’t impact Conduit as much is that there’re other contributors, whilst Synapse and Dendrite are almost exclusively developed by Element.

Right. The current perspective is based on the idea that if Synapse/Dendrite go closed-source right now, an open source version would be good as dead. Element is responsible for 95% of Synapse/Dendrite and I’m sure a community fork would have to play a lot of catch-up to figure out how to keep it going. If the community was more involved in Synapse/Dendrite implementation (and if Element let them) there would be less cause for alarm, as closing the source would just mean an immediate community fork and putting Element on ignore. Also to reiterate, The Matrix Foundation is not going along with Element on this move, and even if Element pulled something shady the Matrix Core Spec etc. would still remain open and under the Foundation’s control, so the max we have to lose is Synapse/Dendrite and all of Element’s developers.

As for the rest I agree and I do actually trust that Element is simply playing their only card here. These maneuvers are all required in order for Element to survive as a company at all, but they also unfortunately leave this backdoor open as a consequence. Matthew has pinky-promised over and over that they are only acting in good faith and that they would never use the backdoor, but it’s understandable that the presence of the backdoor is putting everyone at unease. Best case scenario we take this as a warning sign that if Element drops dead tomorrow then Matrix is also dead. If people want Matrix to not be practically owned by Element then we should diversify and prepare escape plans.

It depends on what your workflow/usecase for putting documents on the drive currently is. Syncthing is usually intended to be put on two separate devices, and then a folder on each device gets synchronized - meaning you have a folder of your documents on each device. Is there any reason not to just mount the network drive’s folder and drag the documents in that way?

This is actually quite a controversial change mainly because of their switch to a CLA. This indirectly gives them the opportunity to switch the license to closed source whenever they feel like it in the future. Semi-controversially, they are also primarly making this AGPL change in order to begin selling dual-licensing to companies. The Matrix Foundation itself does not support this change from Element, though Element is within its rights to do so.

You can read some more thoughts on this from the pessimistic folks at HackerNews. My main takeaway is that I don’t trust Element because I don’t trust anyone. I’m sure they’re doing this in good faith but I don’t like the power they have at the moment. I hope this is what’s needed to begin focusing efforts on alternative homeserver implementations like Conduit.

I haven’t used Kali Linux before, but hcxtools is available in the Debian repos so presumably your /etc/apt/sources.list is invalid (probably the LiveUSB has disabled non-iso sources). Can you post what is in that file?

Edit: Actually it looks like Kali uses a single line for its repo. Can you add

deb http://http.kali.org/kali kali-rolling main contrib non-free non-free-firmware

to your /etc/apt/sources.list, run an apt update and try again?

Syncthing - No introduction needed. Couldn’t live without it.

Healthchecks.io (you can self host this) - Dead man’s switch monitoring for all my automation. Most of my automated scripts hit up a Healthchecks endpoint when they run, and if they fail to hit the endpoint on a regular schedule I get notified. Mandatory for my anxiety.

Flatpak is like an alternative packaging system that exists outside of your distro’s normal packaging model, e.g. apt/dnf/pacman etc. The killer features are that Flatpaks work on any distro with a single universal package, and that the software versions will be cutting-edge without needing cutting-edge system dependencies. Flatpaks run in their own dependency network and generally don’t rely on anything from the host system - this means that you can have arbitrary software on your machine that your distro/repo maintainers don’t need to compile/quality-control/stability-test/etc. It also comes with an easy sandboxing framework out of the box as a bonus.

In my case I usually use Flatpaks to get more current versions of software without totally messing up Debian’s “Debian does not break” stability model - Debian is meticulously maintained so that its “Stable” branch only has ultra-stable versions of software, at the expense of those packages being older and frozen. If you use a distro with smaller package repos (e.g. OpenSUSE/Fedora/etc) you’ll probably appreciate finding Flatpak versions of software that you’d normally need to manually compile.

Flatpaks are cool, and they have a specific use. They’re not the end-all be-all of packaging and they’re (hopefully) not going to replace apt/dnf/pacman. As for why they hate apt I have no idea. apt is good, and you can even make it a little nicer by installing nala and using that instead of apt.

If the basis of this thread is that you’re digging for distro recommendations I’d personally steer you towards Linux Mint and OpenSUSE Tumbleweed for their ease of use. Debian is a little more difficult to set up than Linux Mint but not tremendously so. Arch is more of an “intermediate” difficulty distro where the main challenge is that your system packages are fast-moving and can break/change in small ways from day-to-day. If you aren’t comfortable with Linux you might get frustrated with minor bugs that you don’t know how to troubleshoot. Conversely, if you want to learn Linux then dealing with Arch’s shenanigans will help expose you to various parts of the system naturally.

Did you actually apply the crack over top of the original files? You say you’re running the executable in the CODEX directory, but the CODEX directory would be where the temporary crack files are, not where the game is expecting them. You can also try installing the latest repack from KaOs, which you can find on 1337x by searching for “skyrim repack kaos”. The repack will auto-crack everything so you can be sure that at least that is done correctly.