• partial_accumen@lemmy.world
    link
    fedilink
    English
    arrow-up
    5
    ·
    10 hours ago

    Computer code was translated into audio. That audio was then broadcast over regular radio used for music and news. If you had a cassette recorder and a blank cassette, you could simply record the sound coming out of the speakers of a radio. You then put this recorded cassette into a cassette tape player connected by a wire to your computer so the computer would hear the cassette play. You run a special command on the computer so it starts listening, you press play on the tape and the computer will translate the recorded audio back to computer code. You could then run that program.

    • Buddahriffic@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      10 hours ago

      If you’re familiar with the 56k modem connection song, that’s a similar principle. The telephone line is analog but digital content can be encoded in analog using a DAC, at which point it’s can be interpreted as an audio signal and played through a speaker.

      The sound itself was just data (training patterns, not the actual data of interest, that gets transmitted after the “song”) being encoded at a faster and faster rate, and it would select the fastest speed it could transmit data at reliably along the line. The “song” would progress further the higher the speed it could communicate reliably with the other side, or it might go back and repeat a section because it could negotiate phase (and other parameters) as well as bitrate, which might improve the line reliability, but it still needed to see that test pattern come through cleanly before it would accept a rate.

      • partial_accumen@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        6 hours ago

        Guilty as charged! My C64 is sitting close to me right now. I half considered putting PRESS PLAY ON TAPE in caps just to drive the point home.